NUDA 900 2012/2013 - NUDA 900 R 2012/2013
1
1a
1
2
2
3
6
GENERAL PROCEDURES
Side panels removal
-
Remove the saddle as described in the relevant paragraph.
-
Loosen the five screws (1) and remove the right-hand side (2).
-
Perform the same procedures to remove the left-hand side.
1
H10669
Number plate holder removal
-
Remove the saddle as described in the relevant paragraph.
-
Disconnect the two connectors (1) and (2) of the rear harness.
1
H10729
-
Loosen the two screws (3) that fasten the number holder (4) to the chassis.
4
H10730
-
Remove the saddle fastening pin (5) using a rubber hammer (during the
reassembly, replace the plastic washer (6)).
5
H10731
During the reassembly, tighten the screws with the respective bush-
ings, and position the M6 screw (1a) in the centre part of the side.
E.7
Workshop Manual Ed. 11-2011