Chain Tensioner Removal/Installation - Husqvarna NUDA 900 R 2012 Workshop Manual

NUDA 900 2012/2013 - NUDA 900 R 2012/2013
5
2
4
4
Workshop Manual Ed. 11-2011
CYLINDER HEAD REMOVAL/DISASSEMBLY
- Replace the rubber bushings (6) and the screws (1).
1
6
H10314
- Clean the sealing surfaces and the gaskets.
- Check and if necessary replace the sealing ring (5).
4
- Position the head cover (2) paying attention to the breather opening (arrow).
- The opening (arrow) rests on the sealing ring (5).
- Tighten the screws (4) to torque in a diametrically opposite order.
2
5
5
H10315

Chain tensioner removal/installation

Removal:
- Remove the screw (1) with the sealing ring (2).
- Remove the spring (3) and the chain tensioner (4) from the hole.
1
3
2
H10316
Installation:
- Insert the chain tensioner (4) and the spring (3) in the hole.
- Replace the sealing ring (2) and tighten the screw (1) to torque.
1
3 2
H10317
F2.4