Oil Force Pump Removal/Installation - Husqvarna NUDA 900 R 2012 Workshop Manual

NUDA 900 2012/2013 - NUDA 900 R 2012/2013
1
2
3
4
6
5
8
7
GENERAL ENGINE PROCEDURES

Oil force pump removal/installation

- Remove the complete clutch as described in the relevant paragraph.
Removal:
- Disassemble the retaining ring (4) and the washer (3).
- Disassemble the gear (2).
- Disassemble the drive pin (1).
H10265
- Remove the screws (5).
- Remove the cover (6).
H10266
- Disassemble the rotating piston (7) and the rotor (8), extract the pin (9) from
the shaft.
- Check the condition of the pin (9) and replace it if necessary.
9
H10267
F1.19
Workshop Manual Ed. 11-2011