Husqvarna NUDA 900 R 2012 Workshop Manual page 137

NUDA 900 2012/2013 - NUDA 900 R 2012/2013
21
12
11
8
9
4
6
GENERAL ENGINE PROCEDURES
necessary), making sure the hole (21) is not blocked.
A - Clean the hole (21) if necessary.
- Do not clean the hole with compressed air.
- Apply a layer of Three-Bond 1209 on the contact surface of the pump body
(A).
20
H10280
- Insert the pump body (12) with the driving wheel in the engine head, making
sure the teeth engage with the gear of the camshaft.
- Push the pump (12) all the way down with a suitable pipe bushing, applying
pressure only on the outer edge of the pump.
- Tighten the screw (11) to torque.
H10281
- Fit the impeller (1), screwing it onto the pump shaft.
1
H10453
- Replace the gasket (9) and insert it in the water pump cover (4).
- Fix the cooling ducts (6) to the cover (4).
- Replace the washer (8) and carry out the installation tightening the screws
(7), paying attention to the specified tightening sequence.
7
6
H10283
F1.23
Workshop Manual Ed. 11-2011