Oil Pressure Adjustment Valve Check/Replacement - Husqvarna NUDA 900 R 2012 Workshop Manual

NUDA 900 2012/2013 - NUDA 900 R 2012/2013
9 3
6
5
4 2
1
2
1
2
Workshop Manual Ed. 11-2011
GENERAL ENGINE PROCEDURES
- Tighten the screws to torque, referring to the installation sequence (from 1
to 11).
1 10 7
- Refit the oil sump as described in the relevant paragraph.
8
11
H10432

OIL PRESSURE ADJUSTMENT VALVE CHECK/REPLACEMENT

Removal:
- Remove the swing arm cover as described in the relevant paragraph.
- Disassemble the oil pressure valve (1) with the spring (2).
- Check the condition of the valve.
- Insert the valve in the cover and activate it a few times to check spring elas-
ticity.
- If the valve does not function properly, it must be replaced.
- Check that the seat of the oil delivery valve is not dirty, and clean it if neces-
sary.
- Clean the valve seat.
H10447
Installation:
- Insert the oil pressure valve (1) together with the spring (2) in the cover and
check its operation manually.
- Refit the swing arm cover as described in the relevant paragraph.
H10448
F1.28