Starter Motor Flange Removal; Starter Motor Removal - Husqvarna 2011 TE 630 Workshop Manual

1
3
ENGINE DISASSEMBLY

Starter motor flange removal

2
Remove the ignition cover together with starter drive gear as described in
the relevant paragraph.
- Remove the flywheel with its drive gear;
- Remove the flange (1) (tapping gently on the projections with a rubber ham-
mer) with its gasket (2), the second drive gear (3) and the centring bushings
(4).
- To remove the drive unit (3), remove snap ring (5), washer (6) and seal (7),
and then slide off the drive unit (3) from the opposite end.
H006086
H006087

Starter motor removal

- Remove the starter motor flange as described in the relevant paragraph.
- Loosen the two screws (1) and remove the starter motor (2).
H006088
F.24 Part. N. 8000 H2051 (02-2010)