Interface; Table 3-4. Interface Configuration Jumper Settings - Comtech EF Data SDM-9000 Installation And Operation Manual

SDM-9000 Satellite Modem

3.4 Interface

The interface PCB (AS/3971, AS/4477, or AS/5618) is located in the middle slot of the
modem chassis. The three interface configurations are:
AS/3971
AS/4477
AS/5618-3
Note: The AS/5618-3 G.703 interface assembly supports one 64 kbit/s data channel or
two 32 kbit/s audio channels (per IESS-308, Rev. 8A). The modem can provide
independent transmit (TX) and receive (RX) of audio or digital 64 kbit/s data. This
allows four possible applications:
•
•
•
•
The jumper settings are listed in Table 3-4. Figure 3-4 (AS/3971) and Figure 3-5
(AS/4477) show the interface cards and the locations of jumper JP1.
See Table 3-4 for the appropriate jumper settings for a particular application.
JP1 (EEPROM size select)
Channel
TX
RX
Note: See options, Appendix A for additional timing information.
Rev.4
G.703
ECL/MIL-STD-188-144
G.703 with 64 kbit/s ESC
TX and RX: one 64 kbit/s data channel
TX and RX: two 32 kbit/s audio channels
TX: one 64 kbit/s data channel while RX: two 32 kbit/s audio channels
TX: two 32 kbit/s audio channels while RX: one 64 kbit/s data channel

Table 3-4. Interface Configuration Jumper Settings

AS/3971 Interface Only
Jumper
AS/5618-3 G.703 Interface Only
Jumper
JP7
(Jumper block)
JP6
(Jumper block)
Position Function
1 to 2 27C256 (32K EEPROM)
2 to 3 27C512 (64K EEPROM)
Position Function
1 to 2 64 kbit/s
2 to 3 Audio
1 to 2 64 kbit/s
2 to 3 Audio
Configuration
3–5