Installation Of Accessories - Mitsubishi ECLIPSE CROSS 2017 Owner's Manual

Installation of accessories

NOTE
2 l
While filling with fuel, store the fuel cap in
the cap holder (A) or hang it on the hook (B)
located on the inside of the fuel tank filler
door.
4. Insert the gun in the tank port as far as it
goes.
CAUTION
l Do not tilt the gun.
5. When the gun stops automatically, do
not fill with fuel any more.
6. To close, turn the fuel cap slowly clock-
wise until you hear clicking sounds, then
gently push the fuel tank filler door
closed.
2-04 General information
Installation of accessories
We recommend you to consult
MITSUBISHI MOTORS Authorized Service
Point.
CAUTION
l Your vehicle is equipped with a diagnosis
connector for checking and servicing the
electronic control system.
Do not connect a device other than a diagno-
sis tool for inspections and service to this
connector. Otherwise, the battery could be
discharged, the electronic devices of the ve-
hicle could malfunction, or other unexpected
problems could result.
In addition, malfunctions caused by connect-
ing a device other than a diagnosis tool may
not be covered under warranty.
l The installation of accessories, optional
parts, etc., should only be carried out
within the limits prescribed by law in
your country, and in accordance with the
guidelines and warnings contained with-
in the documents accompanying this ve-
hicle.
l Installing electric components incorrect-
ly could lead to a fire. See the "Modifi-
cation/ alterations to the electrical or fuel
systems" section within this owner's
manual.
OGKE18E1
l
When installing the radio, for the re-
quired information (frequency, transmis-
E00200302651
sion output, installing procedure), con-
your
sult a MITSUBISHI MOTORS Author-
ized Service Point.
If the frequency, transmission output and
installing condition are not appropriate,
it can adversely affect the electronic de-
vices and could lead to unsafe vehicle
operation.
l Using a cellular phone or radio set inside
the vehicle without an external antenna
may cause electrical system interference,
which could lead to unsafe vehicle oper-
ation.
l Tyres and wheels which do not meet
specifications must not be used.
Refer to the "Specifications" section for
information regarding wheel and tyre
sizes.
Important points!
Due to large number of accessory and re-
placement parts of different manufactures
available in the market, it is not possible, not
only for MITSUBISHI MOTORS, but also
for a MITSUBISHI MOTORS Authorized
Service Point, to check whether the attach-
ment or installation of such parts affects the
overall safety of your vehicle.