Gearshift Shaft / Gearshift Cam Plate Removal And Installation - Suzuki GSX1300BK B-King Service Manual

5B-16 Manual Transmission:
Gearshift Shaft / Gearshift Cam Plate Removal
and Installation
Refer to "Engine Assembly Removal in Section 1D
(Page 1D-19)".
Refer to "Engine Assembly Installation in Section 1D
(Page 1D-25)".
Removal
NOTE
It is necessary to remove the engine
assembly from the frame for gearshift system
related parts removal.
1) Remove the gearshift shaft, gearshift cam plate and
gearshift cam stopper. Refer to "Engine Bottom Side
Disassembly in Section 1D (Page 1D-64)".
2) Remove the parts in the figure from the gearshift
shaft.
Special tool
: 09900–06107 (Snap ring pliers)
1
2
3
4
5
1. Washer
2. Snap ring
3. Gearshift shaft return spring
4. Gearshift cam drive plate
5. Gearshift plate return spring
6. Washer
7. Snap ring
B823H15206014
7
1
6
I823H1520031-02
Installation
Refer to "Engine Bottom Side Assembly in Section 1D
(Page 1D-72)".
Install the gearshift shaft and gearshift cam plate in the
reverse order of removal. Pay attention to the following
points:
CAUTION
!
The removed snap rings must be replaced
with new ones.
• When installing the gearshift shaft return spring,
position the stopper "A" of gearshift arm between the
shaft return spring ends "B".
• After installing the gearshift lever, check the gearshift
lever height. Refer to "Gearshift Lever Height
Inspection and Adjustment (Page 5B-14)".
"B"
"A"
I823H1520039-03