5B-14 Manual Transmission:
2) Loosen the lock-nuts (1).
3) Turn the gearshift link rod (2) until the gearshift lever
is 45 – 55 mm (1.8 – 2.2 in) below the top of the
footrest.
4) Tighten the lock-nuts securely.
1
Gearshift Shaft / Gearshift Cam Plate
Components
2
(c)
1. Gearshift shaft
2. Gearshift cam drive plate
3. Gearshift cam plate
4. Gearshift cam stopper
: 10 N⋅m (1.0 kgf-m, 7.0 lbf-ft)
: 13 N⋅m (1.3 kgf-m, 9.5 lbf-ft)
: 19 N⋅m (1.9 kgf-m, 13.5 lbf-ft)
: Apply thread lock to thread part.
: Apply thread lock to thread part.
: Apply grease to oil seal lip.
: Do not reuse.
1
2
I944H1520047-01
B944H15206012
(a)
4
(b)
3
1
I944H1520072-01
Gearshift Construction
1
1. Gearshift shaft
2. Snap ring
3. Gearshift shaft return spring
4. Gearshift plate return spring
: Apply thread lock to thread part.
: Do not reuse.
Gearshift Shaft / Gearshift Cam Plate Removal
and Installation
Removal
1) Disengage the gearshift lever link arm (1) by
removing the bolt.
NOTE
Mark the gearshift shaft head at which the
gearshift link arm slit set for correct
reinstallation.
1
2) Remove the engine sprocket outer cover. Refer to
"Engine Sprocket Removal and Installation in
Section 3A (Page 3A-2)".
3) Remove the clutch components. Refer to "Clutch
Removal in Section 5C (Page 5C-7)".
B944H15206013
2
4
3
2
I944H1520070-02
B944H15206014
I944H1520048-01