Oil Pressure Switch Removal And Installation - Suzuki GSX1300BK B-King Service Manual

1E-10 Engine Lubrication System:
Installation
Install the oil cooler and oil cooler hoses in the reverse
order of removal. Pay attention to the following points:
• Apply engine oil to the O-rings.
CAUTION
!
Replace the O-rings with new ones to prevent
oil leakage.
• Tighten the oil cooler hose bolts to the specified
torque.
Tightening torque
Oil cooler hose bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Pour engine oil. Refer to "Engine Oil and Filter
Replacement in Section 0B (Page 0B-10)".
• Install the removed parts.

Oil Pressure Switch Removal and Installation

Refer to "Electrical Components Location in Section 0A
(Page 0A-7)".
Removal
1) Turn the ignition switch OFF.
2) Remove the under cowling. Refer to "Exterior Parts
Removal and Installation in Section 9D (Page 9D-
14)".
3) Drain engine oil. Refer to "Engine Oil and Filter
Replacement in Section 0B (Page 0B-10)".
4) Disconnect the oil pressure switch lead wire (1).
I823H1150030-01
5) Remove the oil pressure switch (2).
I823H1150031-01
B823H11506006
1
I823H1150013-01
I823H1150014-01