Suzuki GSX1300BK B-King Service Manual page 599

5C-18 Clutch:
• Install the clutch lifter drive cam (4), driven cam (5) to
the clutch sleeve hub (6).
NOTE
• Align the punch mark "C" on the clutch
lifter drive cam (4) with the punch mark "D"
on its driven cam (5).
• The clutch lifter drive (4) and driven (5)
cams should be replaced as a set.
• When replacing the clutch spring support
bolts (7), apply thread lock and tighten
them to the specified torque.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
Tightening torque
Clutch spring support bolt (a): 23 N·m (2.3 kgf-m,
16.5 lb-ft)
5
7
(a)
"C"
"D"
4
6
I823H1530040-01
I823H1530041-03
• Install the clutch sleeve hub along with the clutch lifter
drive and driven cams onto the countershaft.
• Install the conical spring washer (8).
NOTE
The conical carve side of the spring washer
(8) faces outside.
• Hold the clutch sleeve hub using the special tool.
Special tool
(A): 09920–53740 (Clutch sleeve hub holder)
(A)
8
I823H1530042-01
8
I823H1530043-01
I823H1530044-01