Suzuki GSX1300BK B-King Service Manual page 631

9A-7 Wiring Systems:
1. Clamp
: Pass the radiator breather hose above the horn bracket. Be careful not to
contact the lead wires with the horn bracket.
2. Clamp
: Bind the handlebar switch wiring harnesses. Cut off the excess end of the
clamp.
3. Clamp
: Bind the side-stand switch lead wire, regulator/rectifier lead wire and fuel
tank drain hose with the clamp. Do not bind the fuel tank drain hose too tight.
4. Clamp
: Bind the side-stand switch lead wire and regulator/rectifier lead wire at the
front of water bypass hose. Cut the excessive part of the clamp.
5. Clamp
: Bind the left and right handlebar switch harnesses with the harness guide.
Cut off excess end of the clamp.
6. Clamp
: Face the clamp end inside.
7. Clamp
: Cut off the excess end of the clamp and set the locked part facing inside.
8. Harness guide
: Install the harness guide after binding the each lead wire.
9. Fixed clamp
10. Harness guide
11. Regulator/Rectifier lead wire
12. Side-stand switch lead wire
13. Water bypass hose
14. Ignition switch
15. Spacer
16. Cushion
17. Wiring harness No. 2
18. Right handlebar switch lead wire (Red)
19. Left handlebar switch lead wire (Blue)
20. Rear combination light lead wire
21. Rear fender bracket
"A": Do not make slacked part.
"B": Pass the left and right cooling fan and horn lead wires between the
frame and cylinder head.
"C": Pass the starter motor lead wire to right side of the tool box.
"D": Bend the clamp half upward.