Clutch Master Cylinder / Clutch Lever Disassembly And Assembly - Suzuki GSX1300BK B-King Service Manual

• After setting the clutch hose union to the stopper,
tighten the union bolt (3) to the specified torque.
CAUTION
!
The seal washers should be replaced with
new ones to prevent fluid leakage.
Tightening torque
Clutch hose union bolt (b): 23 N·m (2.3 kgf-m,
16.5 lb-ft)
3
(b)
• Bleed air from the clutch system. Refer to "Air
Bleeding from Clutch Fluid Circuit (Page 5C-5)".
Clutch Master Cylinder / Clutch Lever
Disassembly and Assembly
Refer to "Clutch Master Cylinder Assembly Removal and
Installation (Page 5C-8)".
Disassembly
1) Remove the reservoir cap (1), plate (2) and
diaphragm (3).
I823H1530064-01
B823H15306009
3
2
1
I823H1530008-01
2) Remove the clutch lever (4).
3) Remove the clutch lever position switch (5).
5
4) Pull out the push rod (6) and dust boot (7).
5) Remove the snap ring (8).
Special tool
: 09900–06108 (Snap ring pliers)
6
7
Clutch: 5C-9
4
I823H1530009-01
I823H1530010-01
8
I823H1530011-01