Self-Diagnostic Procedures - Suzuki GSX1300BK B-King Service Manual

1A-12 Engine General Information and Diagnosis:

Self-Diagnostic Procedures

Use of Mode Select Switch
NOTE
• Do not disconnect the coupler from ECM,
battery cable from battery, ECM ground
wire from engine or main fuse before
confirming DTC (Diagnostic Trouble Code)
stored in memory. Such disconnection will
erase memorized information in ECM
memory.
• DTC stored in ECM memory can be
checked by the special tool.
• Before checking DTC, read self-diagnosis
function "User mode and dealer mode"
(Refer to "Self-Diagnosis Function
(Page 1A-2)".) carefully to have good
understanding as to what functions are
available and how to use it.
• Be sure to read "Precautions for Electrical
Circuit Service" (Refer to "Precautions for
Electrical Circuit Service in Section 00
(Page 00-2)".) before inspection and
observe what is written there.
1) Remove the right frame side cover. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-14)".
2) Connect the special tool to the mode select switch
coupler at the wiring harness.
Special tool
(A): 09930–82720 (Mode select switch)
3) Start the engine or crank the engine for more than 4
seconds.
4) Turn the special tool's switch ON.
B823H11104002
(A)
I823H1110187-01
5) Check the DTC to determine the malfunction part.
Refer to "DTC Table (Page 1A-20)".
Special tool
(A): 09930–82720 (Mode select switch)
6) After repairing the trouble, turn OFF the ignition
switch and turn ON again. If DTC is indicated (C00),
the malfunction is cleared.
NOTE
• Even though DTC (C00) is indicated, the
previous malfunction history DTC still
remains stored in the ECM. Therefore,
erase the history DTC memorized in the
ECM using SDS.
• DTC is memorized in the ECM also when
the lead wire coupler of any sensor is
disconnected. Therefore, when a lead wire
coupler has been disconnected at the time
of diagnosis, erase the stored history DTC
using SDS. Refer to "Use of SDS Diagnosis
Reset Procedures (Page 1A-14)".
7) Turn the ignition switch OFF and disconnect the
special tool from the mode select switch coupler.
8) Reinstall the right frame side cover.
(A)
I718H1110006-04
I823H1110186-02