Rear Sprocket / Rear Sprocket Mounting Drum Removal And Installation - Suzuki GSX1300BK B-King Service Manual

3A-4 Drive Chain / Drive Train / Drive Shaft:
Rear Sprocket / Rear Sprocket Mounting Drum
Removal and Installation
Removal
1) Remove the rear wheel assembly by disengaging
the drive chain. Refer to "Rear Wheel Assembly
Removal and Installation in Section 2D (Page 2D-
11)".
2) Draw out the rear sprocket mounting drum (2) along
with the rear sprocket (1) from the wheel hub.
3) Remove the rear sprocket nuts and separate the
rear sprocket (1) from its mounting drum (2).
1
4) Remove the retainer (3).
5) Remove the wheel dampers (4).
4
B823H13106003
2
I823H1310012-01
3
I823H1310013-01
I823H1310014-01
Installation
Install the rear sprocket and rear sprocket mounting
drum in the reverse order of removal. Pay attention to
the following points:
• Apply grease to the contacting surface between the
rear wheel hub and rear sprocket mounting drum.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Apply a special tire lubricant or neutral soapy liquid to
the wheel damper surface.
CAUTION
!
• Never use oil, grease or gasoline on the
wheel damper in place of the tire lubricant.
• Three protrusions on the wheel damper
must face outside.
• Tighten the rear sprocket nuts to the specified torque.
Tightening torque
Rear sprocket nut (a): 60 N·m (6.0 kgf-m, 43.5 lb-
ft)
(a)
• Install the rear wheel assembly. Refer to "Rear Wheel
Assembly Removal and Installation in Section 2D
(Page 2D-11)".
I823H1310015-01
(a)
I823H1310016-01