Front Brake Disc Removal And Installation - Suzuki GSX1300BK B-King Service Manual

4B-7 Front Brakes:
Brake Caliper Piston
Inspect the brake caliper piston surface for any
scratches or other damage. If any damage is found,
replace the piston with a new one.
Brake Pad Mounting Pin
Inspect the brake Pad mounting pin for wear and other
damage. If any damage is found, replace the mounting
pin with a new one.
Brake Pad Spring
Inspect the brake pad spring for damage and excessive
bend. If any defects are found, replace them with new
ones.

Front Brake Disc Removal and Installation

Removal
1) Remove the front wheel assembly. Refer to "Front
Wheel Assembly Removal and Installation in Section
2D (Page 2D-4)".
2) Remove the front brake disc.
I823H1420018-01
Installation
Install the front brake disc in the reverse order of
removal. Pay attention to the following points:
• Make sure that the brake discs are clean and free of
any grease.
• Apply thread lock to the brake disc bolts (1) and
tighten them to the specified torque.
: Thread lock cement 99000–32130 (Thread
Lock Cement Super 1360 or equivalent)
Tightening torque
Brake disc bolt (Front) (a): 23 N·m (2.3 kgf-m,
I823H1420019-01
16.5 lb-ft)
I823H1420024-02
1
(a)
1
(a)
B823H14206007
I823H1420021-01
I823H1420022-01