1A-62 Engine General Information and Diagnosis:
P01450-L (Use of SDS)
Step
1
1) Turn the ignition switch OFF.
2) Remove the front seat. Refer to "Exterior Parts Removal
and Installation in Section 9D (Page 9D-14)".
3) Check the AP sensor coupler (1) for loose or poor
contacts.
If OK, then check the AP sensor lead wire continuity.
4) Disconnect the AP sensor coupler.
5) Check the continuity between the G/Y wire and ground.
Also, check the continuity between the G/Y wire and B/
Br wire. If the sound is not heard from the tester, the
circuit condition is OK.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity (
Action
1
)
(A)
Yes
Go to Step 2.
I823H1110124-01
I823H1110019-02
No
R and G/Y wire open, G/
Y wire shorted to the
ground.