Front Brake Master Cylinder Assembly Removal And Installation; Front Brake Master Cylinder / Brake Lever Disassembly And Assembly - Suzuki GSX1300BK B-King Service Manual

4A-10 Brake Control System and Diagnosis:
Front Brake Master Cylinder Assembly Removal
and Installation
Removal
1) Drain brake fluid. Refer to "Brake Fluid Replacement
(Page 4A-6)".
2) Disconnect the front brake light switch lead wires (1).
3) Place a rag underneath the brake hose union bolt (2)
on the master cylinder to catch any spilt brake fluid.
4) Remove the brake hose union bolt (2) and
disconnect the brake hose.
5) Remove the right rear view mirror (3).
6) Remove the master cylinder assembly (4).
4
2
Installation
Install the front brake master cylinder in the reverse
order of removal. Pay attention to the following points:
• When installing the master cylinder (1) onto the
handlebars (2), align the master cylinder holder's
mating surface "A" with the punch mark "B" on the
handlebars (2) and tighten the upper holder bolt first.
Refer to "Handlebar Construction in Section 6B
(Page 6B-2)".
Tightening torque
Master cylinder holder bolt (Upper and Lower)
(a): 10 N·m (1.0 kgf-m, 7.0 lb-ft)
2
"B"
"A"
B823H14106012
3
1
I823H1410020-01
1
(a)
I823H1410022-02
• After setting the brake hose union to the stopper,
tighten the union bolt (3) to the specified torque.
CAUTION
!
The seal washers should be replaced with the
new ones to prevent fluid leakage.
Tightening torque
Brake hose union bolt (b): 23 N·m (2.3 kgf-m, 16.5
lb-ft)
• Bleed air from the master cylinder in the same manner
as caliper side.
Tightening torque
Air bleeder valve (Master cylinder) (c): 6 N·m (0.6
kgf-m, 4.5 lb-ft)
NOTE
If air is trapped in the master cylinder, bleed
air from the master cylinder first.
(c)
• Bleed air from the brake system. Refer to "Air
Bleeding from Brake Fluid Circuit (Page 4A-4)".
Front Brake Master Cylinder / Brake Lever
Disassembly and Assembly
Refer to "Front Brake Master Cylinder Assembly
Removal and Installation (Page 4A-10)".
Disassembly
1) Remove the reservoir cap (1), plate (2) and
diaphragm (3).
2
1
3
(b)
I823H1410021-02
B823H14106013
3
I823H1410024-01