Suzuki GSX1300BK B-King Service Manual page 327

1D-91 Engine Mechanical:
4) Remove the bearings (1).
NOTE
• Do not remove the bearings (1) unless
absolutely necessary.
• Make a note of where the bearings are
removed from so that they can be
reinstalled in their original positions.
CAUTION
!
When removing the bearings, be careful not
to scratch the conrods and the bearings.
1
Installation
1) When installing the conrod bearings, be sure to fix
the stopper part "A" first, and then press the other
side.
NOTE
Inspect and select the conrod crank pin
bearing if necessary. Refer to "Conrod Crank
Pin Bearing Inspection and Selection
(Page 1D-93)".
"A"
2) Apply molybdenum oil solution to the crank pin and
bearing surface.
CAUTION
!
Be sure to clean the conrod big end.
M/O: Molybdenum oil (Molybdenum oil
solution)
3) When fitting the conrod cap, make sure that I.D.
code "B" on each conrod faces intake side.
4) Apply engine oil to the conrod cap bolts.
5) Tighten the conrod cap bolt by using a 10 mm, 12
point socket wrench in the following two steps.
Tightening torque
Conrod cap bolt: 21 N m (2.1 kgf-m, 15.0 Ib-ft)
then turn in 1/4 (90 ) turn
I718H1140269-01
I823H1140578-01
6) Check that the conrod moves smoothly.
7) Install the crankshaft assembly to the crankcase.
Refer to "Engine Bottom Side Assembly (Page 1D-
72)".
I718H1140273-01
"B"
I823H1140277-01
I823H1140278-01
"a "
I823H1140279-01
"a": 90