Suzuki GSX1300BK B-King Service Manual page 510

Installation
Install the engine sprocket in the reverse order of
removal. Pay attention to the following points:
• Apply thread lock to the driveshaft.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
• Tighten the engine sprocket nut (1) to the specified
torque.
Tightening torque
Engine sprocket nut (a): 145 N·m (14.5 kgf-m,
105.0 lb-ft)
• Tighten the speed sensor rotor bolt (2) to the specified
torque.
Tightening torque
Speed sensor rotor bolt (b): 28 N·m (2.8 kgf-m,
20.0 lb-ft)
• Before installing the engine sprocket inner cover,
apply a small quantity of grease to the clutch push
rod.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
1
(a)
I823H1310008-01
2
(b)
I823H1310009-01
Drive Chain / Drive Train / Drive Shaft:
• Install the engine sprocket inner cover (3).
• Tighten the speed sensor mounting bolt (4) to the
specified torque.
Tightening torque
Speed sensor bolt (c): 6.5 N·m (0.65 kgf-m, 4.7 lb-
ft)
• Fit the gearshift link arm to the gearshift shaft so that
the gearshift lever is located at height "a" above the
footrest.
Gearshift lever height "a"
Standard: 55 – 65 mm (2.2 – 2.6 in)
" a "
• Adjust the drive chain slack. Refer to "Drive Chain
Inspection and Adjustment in Section 0B (Page 0B-
15)".
3A-3
4
(c)
3
I823H1310010-01
I823H1310011-01