Suzuki GSX1300BK B-King Service Manual page 334

Selection
1) Remove the right-side thrust bearing and measure
its thickness using the micrometer. If the thickness of
the right-side thrust bearing is below standard,
replace it with a new bearing and measure the thrust
clearance again, as described in 1) and 2).
Special tool
(A): 09900–20205 (Micrometer (0 – 25 mm))
Right-side thrust bearing thickness
Standard: 2.425 – 2.450 mm (0.0955 – 0.0965 in)
4) Select a left-side thrust bearing from the selection table.
NOTE
Right-side thrust bearing has the same specification as the GREEN (12228-24F00-0D0) of left-side
thrust bearing.
Left-side thrust bearing selection table
Clearance before inserting
the left-side thrust bearing
2.560 – 2.585 mm
(0.1008 – 0.1018 in)
2.535 – 2.560 mm
(0.0998 – 0.1008 in)
2.510 – 2.535 mm
(0.0988 – 0.0998 in)
2.485 – 2.510 mm
(0.0978 – 0.0988 in)
2.460 – 2.485 mm
(0.0969 – 0.0978 in)
2.430 – 2.460mm
(0.0957 – 0.0969 in)
5) After selecting a left-side thrust bearing, install it and then measure the thrust clearance again.
(A)
I649G1140343-02
Color "A" (Part No.)
White
(12228-24F00-0F0)
Yellow
(12228-24F00-0E0)
Green
(12228-24F00-0D0)
Blue
(12228-24F00-0C0)
Black
(12228-24F00-0B0)
Red
(12228-24F00-0A0)
"A"
"A": Color code
2) If the right-side thrust bearing is within the standard
range, reinsert the right-side thrust bearing and
remove the left-side thrust bearing.
3) With the left-side thrust bearing removed, measure
the clearance "a" using the thickness gauge as
shown.
Special tool
(B): 09900–20803 (Thickness gauge)
(B)
Thrust bearing thickness
2.475 – 2.500 mm
(0.0974 – 0.0984 in)
2.450 – 2.475 mm
(0.0965 – 0.0974 in)
2.425 – 2.450 mm
(0.0955 – 0.0965 in)
2.400 – 2.425 mm
(0.0945 – 0.0955 in)
2.375 – 2.400 mm
(0.0935 – 0.0945 in)
2.350 – 2.375 mm
(0.0925 – 0.0935 in)
I649G1140345-02
Engine Mechanical: 1D-98
"a"
I823H1140515-01
Thrust clearance
0.060 – 0.110 mm
(0.0024 – 0.0043 in)
0.055 – 0.110 mm
(0.0022 – 0.0043 in)