Suzuki GSX1300BK B-King Service Manual page 462

7) Install the headlight assembly.
8) Install the front fender.
9) Install the front wheel assembly. Refer to "Front
Wheel Assembly Removal and Installation in Section
2D (Page 2D-4)".
NOTE
Before tightening the front axle and front axle
pinch bolts, move the front fork up and down
four or five times.
WARNING
!
After remounting the brake calipers, pump
the brake lever until the pistons push the
pads correctly.
10) Adjust the headlight beam. Refer to "Headlight Beam
Adjustment in Section 9B (Page 9B-6)".
Front Suspension Adjustment
After installing the front fork, adjust the spring pre-load
and two kinds of damping force as follows.
WARNING
!
Adjust the left and right front forks to the
same setting.
Spring pre-load adjustment
• There are five grooved lines on the side of the spring
adjuster.
Position 0 provides the maximum spring pre-load and
position 5 provides the minimum spring pre-load.
• Turn the adjustment (1) to the desired position.
STD position
3rd groove from top
I823H1220084-01
[A]: Position 0
Front Suspension:
1
[A]
[B]
0
1 2
3
[C]
1 2
3 4
5
[B]: Position 3 (STD)
2B-4
I823H1220048-01
0
0
I823H1220049-03
[C]: Position 5