Starter Button Inspection; Specifications; Service Data; Tightening Torque Specifications - Suzuki GSX1300BK B-King Service Manual

Starter Button Inspection

Inspect the starter button in the following procedures:
1) Remove the left fuel tank cover. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-14)".
2) Disconnect the right handlebar switch coupler (1).
NOTE
Red tape "A" is sticked on the right handle
bar switch harness.
"A"

Service Data

Electrical
Unit: mm
Item
Starter motor brush length
Starter torque limiter slip torque
Starter relay resistance

Tightening Torque Specifications

Fastening part
Starter motor housing bolt
Starter clutch bolt
NOTE
The specified tightening torque is also described in the following.
"Starter Motor Components (Page 1I-3)"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Tightening Torque List in Section 0C
(Page 0C-9)".
3) Inspect the starter button for continuity with the
B823H11906011
Special tool
Tester knob indication
Continuity (
Position
1
4) After finishing the starter button inspection, reinstall
I823H1190032-02

Specifications

Specification
Standard
Limit
Standard
(3.3 – 5.2 kgf-m, 24.0 – 37.5 lb-ft)
3 – 5
Tightening torque
N m
5
55
tester.
If any abnormality is found, replace the right handle
switch assembly with a new one. Refer to
"Handlebar Removal and Installation in Section 6B
(Page 6B-3)".
: 09900–25008 (Multi-circuit tester set)
)
Color
B/R Bl/B
PUSH
the removed parts.
12.0 (0.47)
8.5 (0.33)
33.3 – 52.0 N m
kgf-m lb-ft
0.5 3.5
5.5 40.0
Starting System: 1I-13
B/Y
B/W
I718H1190040-01
B823H11907001
Note
B823H11907002
Note
(Page 1I-5)
(Page 1I-11)