Starter Relay Removal And Installation - Suzuki GSX1300BK B-King Service Manual

1I-6 Starting System:
Armature Coil
Inspect for continuity between each segment.
Inspect for continuity between each segment and the
armature shaft.
If there is no continuity between the segments or there is
continuity between the segments and shaft, replace the
armature assembly with a new one.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity set ( )
?
Bearing
Check the bearings for damage.
If any damage is found, replace the armature assembly
with a new one.
Oil Seal
Check the seal lip for damage.
If any damage is found, replace the housing end (inside).

Starter Relay Removal and Installation

Removal
1) Turn the ignition switch OFF.
2) Disconnect the battery (–) lead wire from the battery.
3) Remove the frame cover center lid. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-14)".
4) Disconnect the starter relay coupler (1) and remove
the starter relay cover (2).
5) Disconnect the starter motor lead wire (3) and
I823H1190008-01
battery (+) lead wire (4).
6) Remove the starter relay (5).
Installation
Install the starter relay in the reverse order of removal.
I823H1190033-01
I823H1190034-01
1
2
5
4
3
B823H11906005
I823H1190009-02
I823H1190011-01