Suzuki GSX1300BK B-King Service Manual page 353

1E-12 Engine Lubrication System:
• Apply a small quantity of thread lock to the bolts and
tighten them to the specified torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Piston cooling oil jet bolt (a): 10 N·m (1.0 kgf-m,
7.0 lb-ft)
Oil Jet (For Transmission)
Removal
1) Remove the engine assembly. Refer to "Engine
Assembly Removal in Section 1D (Page 1D-19)".
2) Separate the crankcases, upper and lower. Refer to
"Engine Bottom Side Disassembly in Section 1D
(Page 1D-64)".
3) Remove the oil jet (1) (for transmission oil spray)
from the upper crankcase.
4) Remove the oil jet (2) (for transmission) from the
lower crankcase.
(a)
I823H1150034-01
1
I823H1150035-01
2
I823H1150036-01
Installation
Installation is in the reverse order of removal.
Oil Jet (For Generator)
Removal
1) Remove the generator cover. Refer to "Generator
Removal and Installation in Section 1J (Page 1J-6)".
2) Remove the oil jet (1) (for generator).
Installation
Installation is in the reverse order of removal. Pay
attention to the following point:
• Tighten the oil jet (for generator) to the specified
torque.
Tightening torque
Oil jet (For generator) (a): 5 N·m (0.5 kgf-m, 3.5 lb-
ft)
1
I823H1150037-01
(a)
I823H1150038-01