Drive Chain Replacement - Suzuki GSX1300BK B-King Service Manual

5) Install the rear sprocket mounting drum assembly to
rear wheel hub. Refer to "Rear Sprocket / Rear
Sprocket Mounting Drum Removal and Installation
(Page 3A-4)".
6) Install the rear wheel assembly. Refer to "Rear
Wheel Assembly Removal and Installation in Section
2D (Page 2D-11)".

Drive Chain Replacement

Use the special tool in the following procedures, to cut
and rejoin the drive chain.
NOTE
When using the special tool, apply a small
quantity of grease to the threaded parts of
the special tool.
Special tool
: 09922–22711 (Drive chain cutting and joining
tool)
Drive Chain / Drive Train / Drive Shaft:
Drive Chain Cutting
1) Set up the special tool as shown in the figure.
B823H13106006
1. Tool body
2. Grip handle
3. Pressure bolt [A]
4. Pressure bolt [B]
5. Bar
6. Adjuster bolt (With through hole)
7. Pin remover
8. Chain holder (Engraved mark 500) with reamer bolt M5 x 10
NOTE
The tip of pin remover (1) should be
positioned inside "a" approximately 5 mm
(0.2 in) from the end face of pressure bolt [A]
(2) as shown in the figure.
I649G1310023-02
1
8
6
7
4
3
2
"a"
2
1
"a": 5 mm (0.2 in)
3A-7
5
I649G1310024-02
I649G1310025-02