Suzuki GSX1300BK B-King Service Manual page 450

Step 4
1) To set the EXCV to fully opened position, apply 12 V
to the terminal oppositely.
Positive wire — Gr wire terminal
Negative wire — P wire terminal
CAUTION
!
To prevent the motor damage, stop applying
12 V as soon as the EXCV reaches fully
opened position.
2) Measure the position sensor output voltage at fully
opened position.
EXCVA position sensor out put voltage
EXCV is fully opened: 3.6
V ((+) Y – (–) W)
(B)
I823H1110166-01
Output voltage 4.55
(A)
I823H1110165-02
3) If the measured voltage is more than specification,
adjust the No. 2 cable adjuster as follows:
a) Set the EXCVA to the adjustment position. Refer
to "EXCV Cable Removal and Installation
(Page 1K-5)".
CAUTION
!
Adjusting the No. 2 cable with the EXCV fully
opened can damage the EXCVA. Be sure to
adjust the No. 2 cable with the EXCV set in
adjustment position.
b) Turn out the No. 2 cable adjuster (1) in or out to
set the output voltage within the specified value.
4) After adjusting the EXCV cables, perform Step 2 to
confirm DTC "46" is not indicated.
Exhaust System: 1K-11
1
I823H11B0044-01