Suzuki GSX1300BK B-King Service Manual page 526

Front Brake
1) Fill the master cylinder reservoir to the top of the
inspection window. Place the reservoir cap to
prevent dirt from entering.
2) Attach a hose to the air bleeder valve, and insert the
free end of the hose into a receptacle.
3) Squeeze and release the brake lever several times
in rapid succession and squeeze the lever fully
without releasing it.
4) Loosen the air bleeder valve by turning it a quarter of
a turn so that the brake fluid runs into the receptacle,
this will remove the tension of the brake lever
causing it to touch the handlebar grip.
Brake Control System and Diagnosis:
5) Close the air bleeder valve, pump and squeeze the
lever, and open the valve.
6) Repeat this process until the fluid flowing into the
receptacle no longer contains air bubbles.
NOTE
While bleeding the brake system, replenish
the brake fluid in the reservoir as necessary.
Make sure that there is always some fluid
visible in the reservoir.
7) Close the air bleeder valve and disconnect the hose.
Tightening torque
Air bleeder valve (Front): 6 N·m (0.6 kgf-m, 4.5
lb-ft)
I823H1410005-01
8) Fill the reservoir with brake fluid.
9) Install the reservoir cap.
I823H1410006-01
I823H1410007-01
4A-5
I823H1410043-01