Repair Instructions; Engine Oil And Filter Replacement; Engine Oil Level Inspection; Oil Pan / Oil Strainer / Oil Pressure Regulator Removal And Installation - Suzuki GSX1300BK B-King Service Manual

1E-6 Engine Lubrication System:
4) Warm up the engine as follows:
Summer: 10 min. at 2 000 r/min
Winter: 20 min. at 2 000 r/min
5) After warming up, increase the engine speed to 3
000 r/min (Observe the tachometer), and read the oil
pressure gauge.
If the oil pressure is lower or higher than the
specification, the following causes may be
considered.
Oil pressure specification
200 – 500 kPa (2.0 – 5.0 kgf/cm
at 3 000 r/min, Oil temp. at 60 C (140 F)
High oil pressure
• Engine oil viscosity is too
high
• Clogged oil passage
• Combination of the
above items

Engine Oil and Filter Replacement

Refer to "Engine Oil and Filter Replacement in Section
0B (Page 0B-10)".

Engine Oil Level Inspection

Refer to "Engine Oil and Filter Replacement in Section
0B (Page 0B-10)".
Oil Pan / Oil Strainer / Oil Pressure Regulator
Removal and Installation
Removal
1) Drain engine oil. Refer to "Engine Oil and Filter
Replacement in Section 0B (Page 0B-10)".
2) Remove the under cowling. Refer to "Exterior Parts
Removal and Installation in Section 9D (Page 9D-
14)".
3) Remove the exhaust pipe assembly (1). Refer to
"Engine Assembly Removal in Section 1D (Page 1D-
19)" and "Engine Assembly Installation in Section 1D
(Page 1D-25)".
2
, 28.4 – 71.1 psi)
Low oil pressure
• Clogged oil filter
• Oil leakage from the oil
passage
• Damaged O-ring
• Defective oil pump
• Combination of the
above items

Repair Instructions

B823H11506001
B823H11506002
B823H11506003
6) Stop the engine and remove the oil pressure gauge
and attachment.
7) Reinstall the main oil gallery plug and tighten it to the
specified torque.
CAUTION
!
Use a new gasket to oil leakage.
Tightening torque
Main oil gallery plug (M16) (a): 35 N·m (3.5 kgf-
m, 25.5 lb-ft)
1
(a)
8) Check the engine oil level. Refer to "Engine Oil and
Filter Replacement in Section 0B (Page 0B-10)".
4) Remove the radiator outlet pipe bolt (2) and oil
cooler bracket bolts (3).
5) Remove the left oil cooler hose bolts (4).
3
4
I823H1150003-01
1
I823H1150004-01
1
I823H1150005-01