Connecting A Setup Terminal - Alaxala AX3800S Hardware Instruction Manual

4.10 Connecting a setup terminal

Connect a setup terminal to the CONSOLE port of the Switch.
For this connection, use an RS-232C crossover cable of the inch screw (#4-40) type with
D-sub 9-pin female connectors on both ends.
Figure 4-47 Connection schematic of the setup terminal
(1) Setup terminal
(2) RS-232C cable
(3) CONSOLE port
[Step 1]
Connect an RS-232C cable to the CONSOLE port of the Switch.
Figure 4-48 Connecting the RS-232C cable
(1) RS-232C cable
(2) CONSOLE port
NOTE
Tighten the screws after the connection. Also, confirm that the connector is securely
fastened.
[Step 2]
Connect an RS-232C cable to the setup terminal in the same way.
4. Installation of the Components
171