Error Messages and Codes
Paper Size Mismatch
Applicable Error
Initial Actions
3-52
The size of paper in the Main Paper Tray, or Bypass Tray, does not match the
specified print size.
•
024-958: Paper Size Match
•
Check that the correct paper is in the paper tray. Change the paper if
necessary.
•
Cycle printer power.
•
If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts
Registration Sensor, PL2.3.5
Harness Assembly RKN SNS,
PL2.2.25
MCU Board, PL7.2.2
Troubleshooting Procedure Table
Step
Actions and Questions
1
Check connectors P/J12 and P/J120
between the MCU Board and the
Registration Sensor.
Are the connections secure?
2
Does the error persist?
3
Disconnect the MCU Board P/J12
and the Registration Sensor P/J120.
Check the Harness Assembly RKN
SNS for continuity.
Is the harness damaged?
4
Disconnect the MCU Board P/J12.
Is the voltage across ground and
J12-1 +3.3 VDC?
Xerox Internal Use Only
Wiring and Plug/Jack Map References
"Map 3 - Phaser 6000/6010" on
page 10-9
"Phaser 6000/6010 Feeder" on
page 10-12
"Map 3 - WorkCentre 6015 MFP" on
page 10-23
"WorkCentre 6015 MFP Feeder" on
page 10-26
Yes
No
Go to step 2.
Securely
reconnect the
connectors,
then go to
step 2.
Go to step 3.
Complete.
Repair the
Go to step 4.
harness.
Replace the
Replace the
Registration
MCU Board
Sensor
(page 8-121).
(page 8-65).
Phaser 6000/6010 and WC 6015 MFP