Belt Case Air Cleaner; Final Drive Oil Level - Honda Motorcycle Service Manual

MAINTENANCE
BELT CASE AIR CLEANER
em
CLEANER
On scooters with a cleaner element in the air inlet to the drive
belt case, remove the element and clean.
Wash the element in water and dry
it
thoroughly before
reinstalling.
FINAL DRIVE OIL LEVEL
Check for leakage and proper oil level.
Remove the inspectionilevel hole cap from the gear case and
check that the oil level is up to the lower edge of the hole. If
the oil level is low, refill to the lower edge of the hole with the
recommended oil.
NOTE
Oil level checks should be carried out on level ground
with the vehicle on the center stand.
1
INSPECTION
Refer to the Model Specific service manual for information on
the oil change interval.
OIL CHANGE
Remove the level hole cap from the final gear case.
C+P
Remove the oil drain bolt from the lower portion of the gear
case, slowly turn the rear wheel and drain the oil.
When the oil is completely drained, clean the drain bolt,
replace the sealing washer and tighten to the specified torque.
Refill to the prescribed level with the recommended oil
NOTE
Coat the level hole cap O-ring with oil and replace the cap.
DRAIN'BOLT.-.SEALING
WASHER
Tighten the cap to the specified torque,
Replace the sealing washer if it is damaged.
Date of Issue: March, 1995
0
HONDA MOTOR CO.,LTD.