Drive Pulley Disassembly; Drive Pulley Inspection; Wet Type; Dry Type - Honda Motorcycle Service Manual

V-MATIC BELT DRIVE SYSTEM
DISASSEMBLY
NOTE
.
There are t w o types of movable drive face; wet type
which needs the grease application inside of the face and
dry type which doesn't need grease application.
Remove the movable drive face and drive face shaft from the
crankshaft.
Remove the three bolts attaching the movable drive face seal
and remove the seal.
Remove the ramp plate
WET TYPE:
Remove the weight rollers and the O-rings from the movable
drive face.
DRY TYPE:
Remove the weight rollers from the movable drive face.
MOVABLE DRIVE FACE
BOLTS
'RAMP
MOVABLE DRIVE FACE SEAL PLATE
/
MOVABLE DRIVE FACE
\
I
O-RING
1
WEIGHT
ROLLER
(WETTYPE)
I
The weight rollers push on the movable drive pulley face (by
centrifugal force); worn or damaged weight rollers will in-
terfere with this force.
INSPECTlON
Check the rollers for wear or damage and replace as
necessary.
WEIGHT ROLLER
1
Measure the O.D, of each roller, replace if the service limit is
exceeded.
Date of Issue : March, 1995
0
HONDA MOTOR CO.,LTD.