Clutch/Driven Pulley Disassembly - Honda Motorcycle Service Manual

V-MATIC BELT DRIVE SYSTEM
NOTE
If the pulley holder cannot be used, remove the cooling
fan and hold the flywheel with the universal holder.
rn
UNIVERSAL HOLDER
07725-0030000
Install the left crankcase cover (see Model Specific manual).
DISASSEMBLY
Remove the drive belt and clutchldriven pulley (see page
12-51,
Install a clutch spring compressor on the pulley assembly and
tighten the tool t o gain access t o the nut.
NOTE
Hold the clutch spring compressor i n a vise as shown and
remove the lock nut using the lock nut wrench.
LOCK NUT WRENCH
CI IITCH SPRING
COMPRESSOR
Loosen the clutch spring compressor and disassemble the
clutch and spring from the driven pulley.
i
Remove the seal collar from the driven pulley.
Remove the guide pins and guide pin rollers and the movable
driven pulley face.
Remove the O-ring and oil seals from the movable face.
COLLAR
MOVABLE DRIVEN OIL SEAL
PULLEY FACE
GUIDE
PINS
GUIDE
PIN
0-R~NGS G ~ I D E
PIN ROLLER