Honda Motorcycle Service Manual page 21

GENERAL INFORMATION
TYPES OF FASTENERS
.
Stake-type lock nut
STAKE POINT
;take (or indent1 the collar of the
u t to make it match the groove in
he shaft.
I.
Thread locking agent
Apply a thread locking agent t o the
hread t o prevent loosening.
-.
10. UBS bolt
The threads are pressed by the
,eaction on the inclined bolt flange
APPLICATIONS
Important points inside the
engine
- Clutch center lock nut
Wheel bearing retainer
Shift drum stopper plate
Rotating points inside the
engine, points which if
loosened, may contact
rotating parts.
- Stator coil bolt
- Bearing retainer bolts
- Shift drum stopper plate
bolt
t
Frame
- Fork socket bolts
- Brake disc bolts
-
Used o n critical areas of
the enginelfrarne where a nut
cannot be used to tighten.
Engine;
-
cylinder
- cylinder head
Frame;
- foot peg
-
bracket
CAUTION
During disassembly, eliminate the staking
point to loosen the nut.
Replace the nut, i f the old staked area of the
nut aligns with the groove of the shaft after
tightening the nut t o specified torque.
After tightening the nut to the specified tor-
que, stake the nut collar by striking it with a
drift punch in such a way that the staking
point matches the shaft groove. Ensure that
the staking point has entered into the groove
at least 213 of the groove depth.
.-
Application of a locking agent increases
loosening torque. Take care not to damage
the bolt during removal.
Before applying a locking agent clean off all
oil andlor residual adhesive remaining on the
threads and dry them completely.
Application of an excessive amount of
adhesive may, during loosening, damage the
thread or cause the bolt to be broken. Apply-
ing a small amount of adhesive to the end of
the bolt threads distributes the adhesive
throughout when the bolt is threaded in.
APPLY LOCKING AGENT
IzIam&i
-
Locking agent may cause plastic parts
t o crack. Don't let locking agent touch
plastic parts.
I
The tightening surface where the bolt flange
seats should be level and smooth.
Date of Issue: March.
1995
o
HONDA MOTOR CO..LTD.
1-15