Brake Pad Intsllation - Honda Motorcycle Service Manual

BRAKES
Installation
Press in the piston(s) to install the new pads.
NOTE
-
Clean around the caliper pistons and the expose part of
/
the pistons before Dress in rhe piston.
If the caliper and bracket are separate, apply silicone grease to
the caliper pivot bolt boot, pin bolt, and collar bore and insert
the caliper into the bracket.
Set the boot lip in the pin bolt groove securely.
PAD SPRING
Install the new pad, align the holes in the pad and retainer and
install the pad pin. Note the installation direction of the pad.
NOTE
=al l the pad shim, if there is one, in the original
/
Type A: Install the retainer by aligning its hole with the pad pin
groove and loosely tighten the bolt.
position
Install the caliper. (Refer to the Model Specific manual.)
Type A: Tighten the pad pin retainer bolt to the specified
torque.
Type B: Tighten the pad pin to the specified torque and install
the pad pin plug.
Apply the brake lever to force the caliper piston out of the
caliper.
Rotate the wheel by hand and check the brake operation.
PAD PIN RETAINER
I
PAD PIN RETAINER BOLT
I
TYPE A
I
TYPE B
I
Date of Issue: March.1995
O
HONDA MOTOR CO.,LTD