Limiter Cap Type; Plug Type - Honda Motorcycle Service Manual

FUEL SYSTEM
Limiter cap type
Using a pair of pliers, break off the pilot screw (or air screw)
limiter cap and discard it.
Turn the pilot screw lor air screw) in and carefully count the
number of turns before it seats lightly.
Make a note of this to use as a reference when reinstalling the
pilot screw.
CAUTION
Tightening the pilot (or airl screw against Its seat will
damage the seat.
Remove the pilot (or airl screw and inspect
it.
Replace it i f it is
worn or damaged.
Plug type
Center punch the pilot screw (or air screw) plug to center the
drill point.
Drill through the plug with a 4 mm 15/32 in) drill bit. Attach a
drill stop to the bit 3 mm (118 in) from the end to prevent drill-
ing into the pilot screw.
CAUTION
Use extreme care when drilling into the pilot (or airl
1
I
screw to avoid damaging it.
1
Force a self-tapping 4 mm screw (HIC 069399,
PIN
93903-3541) into the drilled plug and continue turning the
screwdriver until the plug rotates with the screw.
Pull on the screw head with pliers to remove the plug
Use compressed air to clean the screw area and remove metal
shavings.
CARBURETOR
4 mm SCREW
Turn the screw in and carefullv count the number of turns until
I
it seats lightly. Make a note o/ this t o use as a reference when
reinstalling the screw.
CAUTION
Tightening the pilot (or airl screw against its seat will
damage the seat.
Remove the screw and inspect it. Replace it if it is worn or
damaged.
Date of issue: Sep., 1988
o
RONDA MOTOR
co.,
LTD.
8-1
9