Rim Valve Replacement (Tubeless Tire Only); Wheel Center Adjustment (Spoke Wheel Only) - Honda Motorcycle Service Manual

WHEELSITIRES
Remove one side of the bead using same procedures as
described for tubeless tires.
Remove the tire from the rim
RIM VALVE REPLACEMENT
(TUBELESS TIRE ONLY)
Cut off the rim valve at its base.
Apply mild detergent solution to a replacement valve and
insert it from inside of the rim.
NOTE
Be sure to use the recommended rim valve.
.
Do not damage the valve hole.
Replace the rim valve whenever installing a tubeless tire.
WHEEL CENTER ADJUSTMENT
(SPOKE WHEEL ONLY)
The wheel center adjustment is necessary when spoke wheel
has been rebuilt.
The distance indicated is as follows:
A: Between the rim side and the surface standard
B: Rim width (measurement)
C: Between the rim center and the surface standard
NOTE
Refer to the Model Specific manual for the surface
standard and the specific value of "C"
Measure distance B (rim width), and make the following
calculations
Adjust the rim position and distance A by tightening the
spokes to the specified torque in 2 or
3
progressive steps.
Inspect and adjust the wheel rim runout
Date of issue: March, 1995
O
HONDA MOTOR CO.,LTD.