Operation Check; Starter Relay Switch Ground Line - Honda Motorcycle Service Manual

ELECTRIC STARTERISTARTER CLUTCH
<Circuit B%
Measure the voltage between the greeniyellow wire and
ground at the starter relay switch connector.
If battery voltage is measured when the front or rear brake is
applied, the relay is good.
NOTE
If the brake light adjustment is incorrect, no voltage will
appear when the brake is ON.
Starter relay switch ground line
<Circuit A%
Disconnect the connector from the starter relay switch and
check for continuity between the ground wire (greedred) and
ground.
If there is continuity when the transmission is in neutral or
when the clutch is disengaged, the ground circuit is normal.
(In neutral, there is a slight resistance due t o the diode.)
4Circuit 6%
Disconnect the connector from the starter relay and check for
continuity between the ground wire (yellowlredl and ground.
If there is continuity only when the starter switch is pressed,
the ground circuit is normal.
OPERATION CHECK
Take care to prevent direct short between the battery
terminals. The. spark could ignite or damage the
battery.
Apply battery voltage between the two relay coil terminals.
Check for continuity between the B (battery) and
M
(motor)
torminals.
<Circuit A%
Apply battery voltage between the yellowlred and greenired
terminals.
If there is continuity between B and M terminals,operation is
normal
CONNEC
STARTER RELAY
b A
STARTER RELAY SWITCH
Date of Issue: March.1995
o
HONDA MOTOR CO.,LTD.
24-7