Honda Motorcycle Service Manual page 185

CLUTCH
Tighten the lock nut to specified torques using a special tool. a
LOCK NUT WRENCH
I
Stake the nut to the rnalnshaft
Where a staked lock nut is used:
NOTE
I
Replace staked-type lock nuts if the old staked area of
the nut aligns with the groove of the shaft after tighten-
ing the nut to the specified torque.
-
Be careful not to damage the shaft when staking the lock
Make sure that the peen point covers at least 213 of the
width of the mainshaft groove.
PEEN POINT
Set the bearing in the lifter plate, then install the clutch springs
and the lifter plate.
lnstall the clutch spring bolts and tighten them in a crisscross
pattern in 2 or 3 steps.
(Type B)
Install the clutch outer guide, needle bearing and clutch outer
lsee page 11-1 91.
lnstall the clutch center.
Install the lock washer and lock nut (see page 11-20).
Tighten the lock nut using the special tool to hold the clutch
center.
Stake the lock nut If necessary.
CLUTCH SPRING
UT WRENCH
Date of Issue: Nov.. 1989
O
HONDA MOTOR CO.. LTD