Transmission Oil Change; Transmission Oil (2-Stroke Engine) - Honda Motorcycle Service Manual

TRANSMISSION OIL (2-stroke engine)
Check for oil leakage over all sections of the transmission.
Check the oil level.
Excessive oil leakage necessitates disassembly.
CHECK BOLT
With the engine stopped, remove the oil check bolt and make
sure that the oil level is up to the lower edge of the bolt hole.
Refill to the lower edge of the oil level check bolt hole with the
recommended oil if the level is low.
NOTE
.
Oil level checks should be carried out on level ground
with the vehicle on the center stand or while in an
upright position.
P
In scooters, check for leakage and oil level of the final reduc-
tion gear case in the same way as for the engine.
CHECK BOLT
' . .
,
I
.
\\\
Remove the level hole cap from the gear case and check
whether the oil level comes up to lower edge of the hole. If the
level is low, refill to the lower edge of the hole with the recom-
mended oil.
NOTE
.
Oil level checks should be carried out on level ground
with the vehicle on the center stand or while in an
upright position.
. , ~
~,
pared to 4 stroke engines, there is little oil degradation, and the
period for change is longer.
Transmission oil change
Two stroke engine transmission lubrication is achieved by the
Consult the Model Specific manual for the proper oil change
interval.
I
CHECK BOLT HOLE
NOTE
sorav of transmission oil within the sealed crankcase. Com-
.
Oil is more easily drained when the engine is warm.
Remove the oil filler cap.
Remove the drain bolt located at the bottom of the crankcase
and drain the oil.
When all the oil is drained, clean the drain bolt with its sealing
washer and tighten to the designated torque.
NOTE
1
Be sure to replace the sealing washer if
it
is damaged.
1
Remove the oil check bolt, and refill to the prescribed level
with the recommended oil. Replace the check bolt or cap.
DRAIN SEALING
BOLT
WASHERS
2-20
Date of Issue: Sep., 1988
O HONDA MOTOR CO., LTD.