Unit Swing Type Removal; Unit Swing Type Installation - Honda Motorcycle Service Manual

WHEELSITIRES
For hydraulic disc brakes, work the brake disc between the
brake pads. Be careful not to damage the pads.
Align the splines of the driven flange with the splines of ring
gear and push the rear wheel onto the final drive gear.
lnstall the side collar.
NOTE
Be sure the collar is installed properly.
lnstall the axle.
For mechanical drum brakes, connect the brake rod (or cable)
to the brake arm and install the adjusting nut loosely.
Connect the torque rod to the brake panel and tighten the tor-
que rod nut to the specified torque.
Tighten the axle nut first, then tighten the axle pinch bolt to
the specified torque.
For mechanical drum brakes, adjust the rear brake pedal free
play.
UNIT SWING TYPE
Removal
Remove the frame covers and exhaust muffler if necessary.
Apply the rear brake and loosen the axle nut.
NOTE
If the rear axle spins with the axle nut, apply torque to
the wrench allowing the scooter t o tilt rearward and the
rear wheel to contact the ground.
Remove the axle nut and the rear wheel
Installation
lnstall the rear wheel by aligning the splines of the wheel hub
with the final drive shaft splines.
Apply the rear brake and tighten the rear axle nut t o the
specified torque.
NOTE
-
If the rear axle spins with the axle nut, apply torque to
the wrench allowing the scooter to tilt rearward and the
rear wheel to contact the around.
Install the removed parts.
NUT
Date of Issue: March,
1995
o
HONDA MOTOR CO.,LTD.
16-7