Honda Motorcycle Service Manual page 244

RING GEAR BEARING AT'TACHMENT
FINAL DRIVEIOUTPUT SHAFT
Replace the bearing adjustment shim.
RlNG GEAR
\
BEARINC
NOTE
, - - - - - - -
Remove the ring gear bearing using a bearing puller.
NOTE
.
This bearing may not need t o be replaced after removal.
However, inspect the bearing for noise and/or excessive
play after removal
gear set, pinion bearing andlor gear case are
replaced, install a new shim. (Refer t o the Model Specific
BEARING PULLER
(COMMERCIALLY LE)
manual for shim thickness.)
1
Place the bearing on the ring gear.
Drive the bearing over the shaft squarely
Install a new O-ring onto the O-ring guide.
Drive the O-ring guide into the ring gear.
BEARING
DRIVER
7
ATTACHMENT
Date o f Issue: March. 1995
15-12
O
HONOA MOTOR CO.,LTD.