Bottom Race Removal; Top Race Installation; Bottom Race Lnstallation; Steering Stem Bottom Race Replacement - Honda Motorcycle Service Manual

FRONT SUSPENSION
Bottom Race Removal
Set remover B into the steering head, place attachment B onto
remover B, and secure it with nut B.
Install attachment A onto the top of the steering head.
Install the remover shaft through attachments A and B and set
the base with the big end toward the head pipe and screw in
nut A.
Remove the bottom race in the same manner as the top race.
Top Race Installation
Install a new top race and attachment A onto the top of the
steering head.
lnstall the driver shaft, attachment, and base with the small
side of the base toward the steering head as shown.
Tighten nut A.
Hold the driver shaft to prevent the new race from turning, and
install the top race by turning nut A gradually until the groove
of attachment A aligns with the top end of the head pipe.
Bottom Race lnstallation
lnstall a new bottom race and attachment B onto the driver
shaft, and install them into the steering head.
Set attachment A and base on the top of the steering head and
tighten nut A.
Hold the driver shaft securely and install the bottom race into
the steering head by turning nut A gradually until the groove of
the attachment aligns with the bottom of the steering head.
DRIVER SHAFT
DRIVER
ATTACHMENT-
\
BEARING
REMOVER,
.NUT B
LOWER
OUTER
b
- J
SSEMBLY
DRIVER-
ATTACHMENT
L n k ~ ~
B,
55
mm NUT A
NUT A
DRIVER
0 -
ATTACHMENT
A, 4 7 mm
DRIVER
@
LOWER
OUTER RACE\
-
Steering Stem Bottom Race Replacement
I
STEERING STEM
/
Temporarily install the steering stem nut onto the steering
stem t o ~ r e v e n t damaae to the threads.
1
Remove the bottom race and dust seal using a drift, and
discard them.
STEM
NUT
DUST SEAL AND
BOTTOM RACE
18-1
8
Date o f Issue: March.
1995
O
HONDA MOTOR CO.,CTD.