Honda Motorcycle Service Manual page 248

Pull the bearing outer and inner races from the shaft with the
bearing puller.
FINAL DRIVEIOUTPUT SHAFT
NOTE
This bearing may not need to be replaced after removal.
However, inspect the bearing for noise and/or excessive
play after removal
Remove the O-ring from the pinion shaft.
I I
O-RING
BEARING BFARING PULLER
NOTE
Replace the pinion shim.
If the gear set, pinion bearing, ring gear bearing and/or
gear case are replaced, the shim must be replaced.
(Refer to the Model Specifit manual for shim thickness.)
PINION SHIM
,
ATTACHMENT
Drive the pinion gear bearing onto the pinion gear using the
special tool.
Apply gear oil to a new O-ring and install it on the pinion
gear.
PINION
BEARING
-
DRIVER
retainer.
Install a new oil seal on the retainer.
Remove and discard the O-ring and oil seal from the bearing
Coat a new O-ring with gear oil and install it.
OIL SEAL
/
Date of Issue : March. 1995
15-1 6
0
HONDA
MOTOR CO.,LTD.