Honda Motorcycle Service Manual page 51

MAINTENANCE
Locate the drive chain cutter on the staked part of the drive
chain and cut the staked pins.
Drive chain cutter 0 7 H M H - M R l 0 1 0 2
Remove the drive chain.
Remove the excess drive chain links from the new drive chain
with the drive chain cutter.
Standard link: Refer t o the Model Specific service manual.
Replacement chain: Refer t o the Model Specific service
manual.
NOTE
1
I 1
MASTER LINK
1 LlNK
MASTER LlNK
I
One (1) link is indicated as the figure on the right. .
Include the master link when you count the drive chain
STANDARD LlNK
- ? I
Install the new drive chain over the swingarm
CAUTION
I
.
Never reuse the old master link. master link olate and
1
O-rings.
Install the O-rings onto the new master link, and insert the
master link from the inside of the drive chain taking care to
prevent squeezing.
Install the O-rings and the link plate with the drive chain
cutter.
Drive chain cutter 0 7 H M H - M R 1 0 1 0 2
Link plate holder
(Refer t o the Model Specific service manual.)
the outside.
Take care to prevent squeezing of the O-rings.
Do not remove initially applied grease from the link to
lubricate
Remove the special tool and check the master link pin length
projected from the plate.
Standard length: Refer to the Model Specific service
manual.
O-RINGS . *
A
a +
PLATE
**
LINK PLATE HOLDER
1
- .
DRIVE CHAIN CU-ER
STANDARD LENGTH
Date of Issue : March, 1995
O
HONDA MOTOR CO.,LTD