Honda Motorcycle Service Manual page 245

FINAL DRIVEIOUTPUT SHAFT
Remove and discard the oil seal.
Install a new oil seal.
Install the ring gear into the gear case cover.
s
If the clearance exceeds the limit, remove the ring gear. Heat
the gear case cover t o approximately 8 O C (17CF) and
remove the stop pin by tapping the cover.
Measure the clearance between the ring gear and the ring gear
stop pin with a feeler gauge.
.
To prevent burns, always wear insulated gloves when
handlina the heated aear case.
I
Heat the case cover evenly and slowly t o prevent warpage. Do
not heat small areas individually.
CAUTION
-
Case cover warpage can occur if the cover is not heated
properly.
Select a stop pin shim that will provide the correct clearance.
Install the shim and drive the stop pin into the case cover.
Clean all sealing material off the mating surface of the gear
case and cover.
NOTE
Keep dust and dirt out of the gear case.
.
Be careful not t o damage the mating surfaces.
Check the gear tooth contact pattern after the ring gear shim
has been replaced (see page 15-14].
STOP PIN
RING GEAR
/ \
STOP PIN SHIM
Date of Issue
:
March, 1 9 9 5
o
HONDA MOTOR CO.,LTD.
15-13