CLUTCH
Coat the clutch plates and discs with clean engine oil.
Install the judder spring seat and spring, discs and clutch
plates.
NOTE
/
.
The judder spring and spring seat should be installed as
shown.
/
.
The disc that is installed against the judder spring has a
/
larger I.D. than the other discs.
Coat the push rod with grease and install
it
into the mainshaft.
Install the lifter rod (and steel ball, if removed).
Install the bearing i n the lifter plate, then install the clutch
springs, pressure plate, washerb) and clutch spring bolts.
Tighten the clutch spring bolts.
(Type C)
Install the clutch outer guide, needle bearing and clutch outer
(see page 11-1
9).
lnstall clutch center A and the washer.
CLUTCH
DISC
PUSH ROD
1
'
1
\
LIFTER ROD
SPRING, WASHE
BEARING
I
CLUTCH CENTER A
\
I
1-22
Date of Issue: Sep., 1988
O
HONDA MOTOR CO.. LTD.