Two-Piece, Clamp-On Type; Handlebars Removal - Honda Motorcycle Service Manual

FRONT SUSPENSION
Apply a light coating of grease to the throttle cable ends and
THROTTLE GRIP
throttle grip sliding surface.
Connect the throttle cable to the throttle grip and install the
grip to the handlebar.
Install the right handlebar switch, aligning the pin with the hole
in the handlebar.
Tighten the forward screw first, then the rear screw. Check
that the throttle grip moves smoothly and adjust the throttle
grip free play.
Install the brake lever and clutch lever brackets, aligning the
punch marks with:
cable type: slit in the bracket.
.
hydraulic type: master cylinder; set the holder with the
holder punch mark facing up.
Tighten the upper bolts first, then the lower bolts.
Route switch wires properly and secure them with bands
TWO-PIECE, CLAMP-ON TYPE
Removal
Remove the following:
.
Both handlebar switches
Throttle grip
.
Master cylinder(s1 or lever bracket(s1
Remove the stop ring.
Remove the pinch bolt and handlebar.
PUNCH MARKS
STOP RING
I
PINCH BOLT
Date of Issue: March, 1995
18-12
0
HoNDA MOTOR
CO..LTD.